Fuses are ok, device running and using crystal at 12.000MHz.
Tried HIDKeys and PowerSwitch, either manual compile or hex from zip.
Tried 3.3V regulator, diodes after usb 5V, and zener on D+ D- lines.
(checked voltages are ok)
Tried mcu on standalone board, in STK500 with 5v and zeners, and powered via usb with vtarget/aref disabled.
Tried with an Atmega8L and an Atmega16.
I can confirm the interrupt on int0 is triggered.
Usbview shows a low speed device with DeviceFailedEnumeration.
I connected the avr-usb to a Dell 9400 and a Gigabyte motherboard both in usb2.
Same problem on both machines.
Any clue ?
Is there more debugging that can be done like changing a status line when the descriptor is sent ?
The assembler code is tight.... and I never coded in assembly.
Thanks for any ideas
Chris.