HIDKeys on Atmega328P
Posted: Mon Dec 20, 2010 7:42 pm
Hello!
I've got my Atmega 328P up and running with the Powerswitch project and it is working flawlessly. Some tweaking had to be made so it used the correct pins and i had to flash the fuse bytes. When i connect it to my linux computer it says
once (as it should) and then i can send commands to it using the command line program. Great!
But now i wanted to get the HIDKeys project running and I seem to be out of luck. I'm using 12M external osc and 2 rectifier diodes for level conversion (this worked in the Powerswitch project). I've edited mmcu flag so it says mega328p in the Makefile. The code compiles fine, but when i connect the project then i get the following:
And when i connect it to a windows computer i get the Device unknown message.
Can anybody help?
I've got my Atmega 328P up and running with the Powerswitch project and it is working flawlessly. Some tweaking had to be made so it used the correct pins and i had to flash the fuse bytes. When i connect it to my linux computer it says
Code: Select all
kernel: usb 2-2: new low speed USB device using uhci_hcd and address 78once (as it should) and then i can send commands to it using the command line program. Great!
But now i wanted to get the HIDKeys project running and I seem to be out of luck. I'm using 12M external osc and 2 rectifier diodes for level conversion (this worked in the Powerswitch project). I've edited mmcu flag so it says mega328p in the Makefile. The code compiles fine, but when i connect the project then i get the following:
Code: Select all
kernel: usb 2-2: new low speed USB device using uhci_hcd and address 90
kernel: usb 2-2: new low speed USB device using uhci_hcd and address 91
kernel: usb 2-2: new low speed USB device using uhci_hcd and address 92
kernel: usb 2-2: new low speed USB device using uhci_hcd and address 93
And when i connect it to a windows computer i get the Device unknown message.
Can anybody help?