PPM RC to USB Interface Problems
Posted: Thu Nov 22, 2007 11:08 pm
Hi,
i build the interface and programm the sample programm to to mega 8.
when i connect the interface the computers says "USB-Gerät wurde nicht erkannt" (german). This messages appears every 5 seconds.
Did anyone have the same problem ?.
The AVR is 8 Mega8 (not L) is this a problem ?
And in the Project Archive i found no information about the fuses.
Can anyone help me ?
Regards,
Joern
i build the interface and programm the sample programm to to mega 8.
when i connect the interface the computers says "USB-Gerät wurde nicht erkannt" (german). This messages appears every 5 seconds.
Did anyone have the same problem ?.
The AVR is 8 Mega8 (not L) is this a problem ?
And in the Project Archive i found no information about the fuses.
Can anyone help me ?
Regards,
Joern