PPM RC to USB Interface Problems

General discussions about V-USB, our firmware-only implementation of a low speed USB device on Atmel's AVR microcontrollers
Post Reply
Joernhall
Posts: 2
Joined: Thu Nov 22, 2007 11:03 pm

PPM RC to USB Interface Problems

Post by Joernhall » Thu Nov 22, 2007 11:08 pm

Hi,

i build the interface and programm the sample programm to to mega 8.
when i connect the interface the computers says "USB-Gerät wurde nicht erkannt" (german). This messages appears every 5 seconds.
Did anyone have the same problem ?.
The AVR is 8 Mega8 (not L) is this a problem ?
And in the Project Archive i found no information about the fuses.

Can anyone help me ?

Regards,
Joern

Joernhall
Posts: 2
Joined: Thu Nov 22, 2007 11:03 pm

Post by Joernhall » Fri Nov 23, 2007 10:49 pm

Hi,

problem solved !
the voltage reglator was defect.

Post Reply