Objective Development Forums

Hi all!
I've downloaded the newest version of WinAVR
Then, i installed it for recompiling the firmware, when i compiled it to the file.hex into the folder that i used to contain the makefile and file.c but i couldnt see my file.hex anywhere?
should i make something else for the compilation process in WinAVR?
could anyone help me?

Does this version of WinAVR use the Makefile or does it control the build process by itself? If it uses the Makefile, it depends on the rules in the Makefile whether a .hex file is created or not.

Thanks Christian!
I had the answer on the AVRFreaks forum!