Verify correct enumeration?

[guscrown]

Is there a way to confirm correct enumeration? This way we can trigger a "disconnect" and "reconnect" to attempt enumeration again. Or what about a way to tell if the device was de-enumerated?

[guscrown]

If anybody else is wondering you can use usbDeviceAddress, I believe it is a global variable; if it's "0" it means the device was not enumerated. If it's different than "0" it means it was.

Alternatively, people have been using usbSofCount to monitor the host-device link, but to do this you have to wire D- to INT0. I will test this option on Monday when I have access to my board again.