Objective Development Forums

Hi,

I have a simple questen (and I hope that the answare is simple too ).

Anybody knows if there is a way to detect if the USB cable ist connectet, and the enumeration is done successfully, by firmware? I don't have more pins available on my ATmega32 to detect the USB cable, so I'm trying to do it by software.

By the way, I'm working with the firmware of PowerSwitch.2007-03-29. Should I do a update to the newer version? My device is working fine, but I read something about problems wich appear sporadically (USB connection fails after some hours inactive), with the older version.

Regards,
Mario

You can check for SOF frames which come in 1 ms intervals if the device is connected to a host. The easiest way to do this is to (1) wire INT0 to D- instead of D+, (2) update to the latest driver version and (3) define USB_COUNT_SOF in usbconfig.h.

Then you can check whether the global variable usbSofCount increments every millisecond.

Hi Christian,

thank you for your answare. Just one more question, where I should connect D+, if I connect D- to the INT0? I read in the usbconfig.h that D+ must be connected to INT0.

I'm already using the new driver version. The update was very easy, and the USB-communication still working great.

Regards,
Mario

The newer versions of the driver don't really care whether you connect D+ or D- to INT0. For counting frames, however, you MUST connect D- to INT0 because only D- carries the frame marker.