Error in RemoteSensor Rx board
Posted: Mon Nov 27, 2006 12:02 pm
RemoteSensor's receiver board up to version 2006-03-14 has an error: The USB connector is wired in reverse order (pin 1 should be pin 4, 2 should be 3 and so on).
When you build the board from the schematic/board file of the project, positive an negative supply are swapped. This has undesirable effects on the voltage regulator and the receiver module!
When you build the board from the schematic/board file of the project, positive an negative supply are swapped. This has undesirable effects on the voltage regulator and the receiver module!