Crystal-less RC calibration error tolerance

General discussions about V-USB, our firmware-only implementation of a low speed USB device on Atmel's AVR microcontrollers
Post Reply
BarsMonster
Posts: 9
Joined: Wed Mar 03, 2010 9:30 pm

Crystal-less RC calibration error tolerance

Post by BarsMonster » Wed Mar 24, 2010 8:01 am

Hi there, I just managed to run my first V-USB project on Mega48 without crystal, and did small investigation on working OSCCAL range:
Autodetected OSCCAL is 0xF1-0xF2 for both 3.3 and 5v power supply.
Device still works in 0xEF-0xF6 range, so it is not as fragile as I've thought.

Post Reply