Problems with ATMega1280 and V-USB
Posted: Sat May 21, 2011 5:26 am
Hello,
Im trying to use the ATmega1280 (Arduino mega) with VUSB, but looks like i'm not able to configure the port / pins correctly.
My usb circuit is ok (tested with an Arduino UNO).
I'm using PD0 for D+ (INT0) and PD1 for D-.
Is this setup right?
Thanks in advance,
Im trying to use the ATmega1280 (Arduino mega) with VUSB, but looks like i'm not able to configure the port / pins correctly.
My usb circuit is ok (tested with an Arduino UNO).
I'm using PD0 for D+ (INT0) and PD1 for D-.
Is this setup right?
Thanks in advance,