Page 1 of 1
AVR-USB and Windows Vista
Posted: Sun Jun 29, 2008 7:49 pm
by Guest
Is there any chance AVR-USB CDC will run on Vista in the future?
AVR-CDC on Windows Vista
Posted: Tue Jul 01, 2008 8:19 am
by Osamu
Posted: Fri Jul 04, 2008 1:30 am
by Guest
Great Work!
I have just tested it; it works perfect.
Now i can use AVR-Doper with AVR-Studio in Windows Vista.
Thanks a lot!
Posted: Mon Jul 28, 2008 2:41 pm
by Guest
Hi Guys,
I am running the AVR-Doper in CDC mode on vista.
have installed the above drivers. they seemed to have gotten me a little closer to a working programmer.
AVR Studio 4.14 sees the programmer as an STK500 v2. it actually asks to upgrade from 2.04 to 2.0A - i say NO.
But after this it always fails to enter programming mode - what do i need to do to get it to work.
I also use Codevision AVR (a C compiler) - but this also says that it cannot enter programming mode on the STK500.
The AVR-Doper boards RED LED blinks for a second then goes off. then the error pops up.
I have not set any fuse bits on the ATmega8 - what do i need to set?
What do i set the SCK to? I have tried all avaiable speeds...
Matt
Yes.