Objective Development Forums

Hi,

anyone has a _real_ working version for the 128k flash version?

The access to the upper 64k page for the device descriptor does not work on my at90can128.
AVR catches the start of the communication, but does not move any further after the request for device descriptor, because of the address above 0x1E000.

Thanks in advance.

Regards
dg

More infos:

I know about the pgm_read_far solution, but there is a pointer named like usbmsg, which is still only 16 bit and can not store a 24bit wide address.

In usbportability.h there is a switch for handling the memory pages:

#if USB_CFG_DRIVER_FLASH_PAGE
# define USB_READ_FLASH(addr) pgm_read_byte_far(((long)USB_CFG_DRIVER_FLASH_PAGE << 16) | (long)(addr))
#else
# define USB_READ_FLASH(addr) pgm_read_byte(addr)
#endif

The include order in usbdrv.c is

#include "usbportability.h"
#include "usbdrv.h"

It means USB_CFG_DRIVER_FLASH_PAGE is not known for usbportability.h, so no FAR access is generated.
By adding #include "usbconfig.h" before #include "usbportability.h" solves the problem, my devices reports itself correctly.

Didn't want to start an extra thread for this:

When uploading the bootloader to an at90can128 you have to set the BOOTLOADER_ADDRESS in the makefile to 0x1E000 and change:

to


otherwise it would always throw an out-of-range error when trying to flash (I used avrdude with a jtagmkI-compatible dongle if it matters) the bootloader.


Also, thanks to dg for solving the memory issue, I had the same problem.