Error in RemoteSensor Rx board

General discussions about V-USB, our firmware-only implementation of a low speed USB device on Atmel's AVR microcontrollers
Post Reply
christian
Objective Development
Objective Development
Posts: 1442
Joined: Thu Nov 09, 2006 11:46 am

Error in RemoteSensor Rx board

Post by christian » Mon Nov 27, 2006 12:02 pm

RemoteSensor's receiver board up to version 2006-03-14 has an error: The USB connector is wired in reverse order (pin 1 should be pin 4, 2 should be 3 and so on).

When you build the board from the schematic/board file of the project, positive an negative supply are swapped. This has undesirable effects on the voltage regulator and the receiver module!

Post Reply