Objective Development Forums

ESD protection

2007-06-07T20:05:09+02:00

The 1N4148 in Automator is for decoupling, not for ESD protection.

Atmel should have a data sheet specifying ESD robustness of the chip. I have not found it in the standard device data sheet, though. They have diodes to V+ and GND on each pin.

Designing a REAL ESD protection is not easy. It's not only about choice of components and values, it's also the physics of the board (stray inductivities and capacities).

In practice, you should get away with the AVR's internal protection, especially since there are series resistors on D+ and D-. If you don't use a voltage regulator, you also need zener diodes which offer additional protection.

Statistics: Posted by christian — Thu Jun 07, 2007 8:05 pm

ESD protection

2007-06-07T19:08:28+02:00

Thanks for reply.

I'm a begginer, i didn't known that avr have some protection against ESD. Do you know how strong this protection is? The avr will survive ESD up to 15kv?

In Automator project i've seen the diode 1N4148, this is against ESD ?

Do you know how to design the ESD protection (or have some links to read)?

Thanks!

Statistics: Posted by Guest — Thu Jun 07, 2007 7:08 pm

ESD protection

2007-06-07T14:33:12+02:00

These circuits are designed to be as simple as possible. The AVR controller itself has some protection against ESD built-in. If you expect a hostile environment, you should add a dedicated ESD protection.

Statistics: Posted by christian — Thu Jun 07, 2007 2:33 pm

ESD protection

2007-06-05T02:34:27+02:00

I didn't seen any protection from ESD in hardware implementation. What about ESD protection? There'a nothing to worry ? The USB connectors protect from ESD, or sth... ?

Thanks in advance. Cheers!

Statistics: Posted by Guest — Tue Jun 05, 2007 2:34 am