Objective Development Forums

3.3v zener instead of 3.6v zener

2008-10-10T17:31:47+02:00

Yes, looks OK. But please also check the idle voltage on D-. It should be above ~ 3 V.

Statistics: Posted by christian — Fri Oct 10, 2008 5:31 pm

3.3v zener instead of 3.6v zener

2008-10-10T02:57:37+02:00

Sounds good to me

Statistics: Posted by Grendel — Fri Oct 10, 2008 2:57 am

3.3v zener instead of 3.6v zener

2008-10-10T02:15:00+02:00

i see, anyway i risked my avr (tiny2313) yasterday with a pair 3.3v zener ( i use BZX55/C3V3 ) it worked, however i should lower the series resistor to 47, if i use 68 it won't work though. So is this okay to do this? i checked the voltage on d+ and d- with osciloscope it swinging around 3.4v - 0v is this okay?

Statistics: Posted by shoujin — Fri Oct 10, 2008 2:15 am

3.3v zener instead of 3.6v zener

2008-10-09T16:54:38+02:00

Someone also suggested a green and an orange LED in series. The forward voltage should be pretty close to 3.3 V.

Since LEDs can differ depending on efficiency etc, measure the voltage before you use them.

Statistics: Posted by christian — Thu Oct 09, 2008 4:54 pm

3.3v zener instead of 3.6v zener

2008-10-09T09:19:49+02:00

Worked for me using a Mega8, didn't work w/ a Tiny461. Turned out the I/O pin threshold voltages are different and I had to use 3.6V w/ the Tiny (3.6 worked w/ the Mega as well). If you want to play it save use 3.6V, <= 500mW.

Statistics: Posted by Grendel — Thu Oct 09, 2008 9:19 am

3.3v zener instead of 3.6v zener

2008-10-09T03:21:13+02:00

okay i need some information about this matter, everytime i saw the example project all the zener used is 3.6v, my question is simple is it possible to use 3.3v zener instead of 3.6v zener?

Statistics: Posted by shoujin — Thu Oct 09, 2008 3:21 am